Indelac – Safe-n-Secure Electric Actuator with Internal Battery Fail-safe
Overview
The Safe & Secure Series is a compact powerful solution for critical applications. Equipped with an internal
battery this unit is field adjustable to fail closed, fail open, or continue standard operations, always leaving you
in control during sudden loss of utility power and/or control signal.
Introduction
Enclosure options include: NEMA 4, 4X, 7 and 9. The heavy-duty sand-cast aluminum enclosure has a thermally bonded ultraviolet resistant polyester powder coating that not only enhances its appearance but also is a tough corrosion resistant coating. Anodizing and epoxy coatings are offered as well.
NEMA 7 and 9 enclosures are perfect when the application requires equipment rated for Class I Groups C & D and Class II Groups E, F & G div. I and II environment. Despite a hostile environment, the Safe and Secure built in this explosion-proof enclosure can get the job done and lower the overall risk factor of the installation.
Safe & Secure Series is available in 115Vac, 230Vac, 12Vdc, 24Vdc, and 24Vac operating voltages to guarantee electrical compatibility and reliability with any process control around the world. It is equipped with 300 series stainless steel output shaft and heavy duty spur gear drive which, as in all ICI electric actuators, can withstand stall conditions without suffering gear failure.
Technical specifications
TORQUE:
SNS4 400 In-Lb (45.2 Nm)
SNS6 675 In-Lb (76.3 Nm)
SNS10 1,000 In-Lb (113 Nm)
SNS15 1,500 In-Lb (169.5 Nm)
CYCLE TIME:
SNS4 10 sec. / 90°
SNS6/10 15 sec. / 90°
SNS15 30 sec. / 90°
DUTY CYCLE:
100%
MOTOR:
Brush type 12Vdc (for all input voltages)
SWITCHES:
SPDT snap action, 15 Amps @ 250 Vac
TEMP. RANGE:
-40°F to 150°F
Heater & Thermostat required 0°F & below
BATTERY TYPE:
12 Volt 0.8 AHr, Rechargeable Sealed Lead Acid Battery, Minimum 4 Years Life in Stand-By Use at 68°F
CHARGER:
Trickle charger drawing 1 to 1.3A during battery recharge and 50mA to maintain to full charge